Uvp ChemiDoc-It Imaging System Manual do Utilizador

ChemiDoc-It® Imaging System Instruction Guide __________________________________________________________________________

ChemiDoc-It Imaging System 10 Software Installation All of the software required to operate the MegaCam 810, OptiChemi 610 and BioChemi 510 cameras

ChemiDoc-It Imaging System 11 Operation Using the System The master power switch is located on the upper right side of the darkroom (see picture b

ChemiDoc-It Imaging System 12 Capturing Images and Using Templates Focusing the Lens Using VisionWorksLS Preview 1. Place the sample or focus targ

ChemiDoc-It Imaging System 13 Using Templates Set Up and Save Camera Templates NOTE: Without using templates, camera settings can be manually adjus

ChemiDoc-It Imaging System 14 Service Procedures Return Procedure A Returned Goods Authorization (RGA) number must be obtained from UVP Customer Se

ChemiDoc-It Imaging System 2 Table of Contents Table of Contents ...

ChemiDoc-It Imaging System 3 Introduction The ChemiDoc-It Imaging System is designed to automate chemiluminescence-based research with one-touch, p

ChemiDoc-It Imaging System 4 Components The ChemiDoc-It Imaging System is comprised of the following equipment:  Darkroom Cabinet  CCD Camera:

ChemiDoc-It Imaging System 5 Setup Instructions Installing VisionWorksLS Software 1. Insert the VisionWorksLS flash drive into the computer. 2. C

ChemiDoc-It Imaging System 6 8. If the computer is not connected to the Internet, click Offline activation to register the software. This allows

ChemiDoc-It Imaging System 7 Motorized Lens Controller Setup The camera, lens and lens controller are all connected at the factory and come shipped

ChemiDoc-It Imaging System 8 Note: The MegaCam 810, OptiChemi 610 and BioChemi 510 cameras use many of the same components and are installed in a s

ChemiDoc-It Imaging System 9 Installation with Manual Lens (BioChemi 510 and OptiChemi 610 Only) The photograph shows the par